BS SİNEKLİK - PERDE SİSTEMLERİ

English EN
0541 495 76 22

How to Measure for an Insect Screen: Step by Step

The steps to accurate measuring: which points to measure, which value to use and the most common mistakes.

How to Measure for an Insect Screen: Step by Step

Most problems with insect screens come not from production but from incorrect measurements. If you need to take the measurements yourself, the steps below reduce the margin of error.

## 1. Decide on the system type first

Measurements are taken at different points depending on the system. For a fixed-frame insect screen the clear opening of the frame is used, for a sliding insect screen the outer frame line, and for a hinged system the door opening. Measurements taken before the system is decided often have to be taken again.

## 2. Measure the width at three points

Measure the width at three points: top, middle and bottom. Frames can end up a few millimetres out of true over time or during installation; the three measurements are rarely exactly the same.

Production is based on the **smallest** value. A sash made to the largest value will jam at the narrow point.

## 3. Measure the height at two points

Measure the height separately at the left and right edges. Here too the smallest value is used. If the difference is significant (more than a few millimetres), note it separately; it may need to be compensated during installation.

## 4. Note the opening direction

For hinged systems, the side on which the sash opens, and for sliding systems, the direction in which the frame's sash slides, directly determine production. A product made without this information may turn out reversed on site.

For multi-sash sliding frames, marking which pane opens on a simple sketch is the safest method.

## 5. Check the mounting surface

State whether the frame is PVC, aluminium or timber. The fixing brackets and screws are chosen according to the surface.

Also note whether there is a windowsill, drip edge or outer frame projection in front of the frame that could obstruct installation. These details are the most common cause of surprises on site.

## The most common mistakes

**Measuring at a single point.** The frame being out of true goes unnoticed and the sash jams on one side.

**Using the largest value.** The "make it a bit bigger, we'll trim it" approach is an assumption that does not work in production; the sash will not fit into the frame.

**Measuring over the existing screen.** The old product may also have been made to the wrong measurements. Always measure the frame.

**Not stating the opening direction.** Especially with hinged systems, this makes the product unusable.

## Let us measure for you

On-site measuring is free of charge in Kayseri and in all areas we serve. If you prefer to send the measurements yourself, simply follow the steps above and give us the three width values and two height values together.

WhatsApp
Message Now
Call Now
0541 495 76 22